Lysol Disinfectant Spray kills 99.9% of bacteria and viruses, including cold, flu, and coronavirus (when used as directed). This disinfectant spray sanitizes, disinfects and eliminates odors. Use this disinfecting spray on high touch hard surface areas. Let Lysol bring you and your family peace of mind when it comes to disinfecting against germs. You can also use this disinfecting spray on soft surfaces, like couches, coats, sports bags, strollers and backpacks. How to Use Lysol Disinfecting Spray? To Sanitize and Disinfect: Pre-clean surface. Hold can upright 6″ to 8″ from surface. Spray 3 to 4 seconds until covered with mist. To Sanitize: surfaces must remain wet for 10 seconds then allow to air dry. To Disinfect: hard surfaces must remain wet for 3 minutes then allow to air dry and soft surfaces must remain wet for 10 minutes and then allow to air dry. To Control Mold and Mildew: (1) Apply to a pre-cleaned surface. (2) Allow to remain wet for 3 minutes. (3) Let air dry. (4) Repeat applications in weekly intervals or when mold and mildew growth appears. For more than a century, Lysol has been helping to protect families from illness-causing germs. To learn more about our mission and find further disinfecting solutions, solutions for household cleaning, and disinfectant spray products, visit our website or check out our instagram. Ingredients: Other Ingredients: 41.90%, Total: 100.00% Directions: Directions for Use: It is a violation of federal law to use this product in a manner inconsistent with its labeling. Read the entire label before using the product. Pre-clean surfaces prior to use. Hold can upright 6 inches to 8 inches from surface. Spray 3 to 4 seconds until covered with mist. To Deodorize: Spray on surfaces as needed. To Sanitize: Surfaces must remain wet for 10 seconds then allow to air dry. To Disinfect: Surfaces must remain wet for 3 minutes then allow to air dry. For norovirus, hepatitis A virus, adenovirus 2, fusarium solani and mycobacterium bovis bcg (quant tuberculosis surface must remain wet for 10 minutes then allow to air dry. Rinse toys and food contact surfaces with potable water after use. Fabric Sanitizer: For spot treatment (2 inch x 2 inch area) only. To Sanitize/disinfect soft surfaces: Spray until fabric is wet. Do not saturate. Fabric must remain wet for 30 seconds. Let air dry. For difficult odors, repeat application. To Control and Prevent Mold & Mildew: Apply to pre-cleaned surface. Allow to remain wet for 3 minutes. Let air dry. Repeat applications in weekly intervals or when mold and mildew growth appears. Do not use on polished wood, painted surfaces, leather, rayon fabrics, or acrylic plastics. Do not use on silk, rayon acetate or satin fabrics. Always test on a hidden area of fabric. Storage and Disposal: Store in original container in areas inaccessible to small children. Do not reuse empty container. Do not puncture or incinerate! Discard in trash or offer for recycle, if available. Warnings: For
